Inquiry:

SubmittedStatus
2023-07-10 13:20:41 Resolved (No IP Change)

YearMakeModelBody
2023 BMW 440i Coupe

Tracking # 31277
Resolution

Estimated Release Date: Closed
Proposed Resolution: MOTOR stated:
After review, the refinish time for the Bezel is included with the estimated refinish time applied to the Bumper Cover.

Please note: If the Bezel needs to be removed for refinishing purposes this would require an on-the-spot evaluation. According to the MOTOR Guide To Estimating, material cost are not included in any labor operations.


Inquiry type Non-Welded Panel Operations
Area of Vehicle Rear Bumper
Issue Summary The PDC sensor bezel is pre-installed at the factory, but is too tight against the opening to produce a quality finish. Basecoat/Clearcoat ends up pooling in the seam and causing a run or a poor finish. The bezel must be removed off the new bumper, the opening sanded and re-primed, and then be bezel painted separately off the bumper. Afterwards, it needs to be reinstalled/bonded with Adhesive Set K6.
Technician Skill Level Expert
Suggested Action Is the material and labor needed to perform these step included with refinishing the bumper? If not, please add the appropriate refinish labor to the bezels, and add a footnote.